For soldier-course lintels with low masonry height

Single-bracket anchors EK-G

The MOSO single-bracket anchor type EK-G is the cost-efficient answer for soldier-course lintels with low masonry height.

Corner lintels can also be produced without difficulty by using version EK-GE.

Constant stock of standard sizes for fast delivery
Very simple installation
Cost-effective version for smaller load ranges
Wall clearances greater than 200 mm are also possible for increased thermal insulation. As well as our MOSO support brackets, we will obtain specific approval for our air gap wire anchor based on DIN 1053
We also supply the matching, approved air gap wire anchors at low cost

Single-bracket anchors EK-G

0,3kN - 0,8kN
20 - 200 mm

approved stainless steel
type-testing or structural analysis

approved stainless steel

type-testing or structural analysis

Single-bracket anchors EK-G

• For invisibly supporting lintels with low masonry height.

• Can also be used near corners and edges.

• When using frost-resistant bricks with poor mortar bonding, the bricks should be pinned additionally.

• Choice of single-bracket anchors is not dependent on the length of lintel.

• Single-bracket anchors set at intervals of ak = 25 cm.
For invisibly supporting lintels with low masonry height.
Can also be used near corners and edges.
When using frost-resistant bricks with poor mortar bonding, the bricks should be pinned additionally.
Choice of single-bracket anchors is not dependent on the length of lintel.
Single-bracket anchors set at intervals of ak = 25 cm.

Single-bracket anchors EK-G

Technical data
Type / Version	Load stage	0,3 kN		0,8 kN
Type / Version	Distance/wall	Cantilever length K	Bracket height x	Cantilever length K	Bracket height x
	10 - 30	95	55	95	55
	30 - 50	115	55	115	55
	50 - 70	135	65	135	65
	70 - 90	155	75	155	75
	90 - 110	175	85	175	85
	110 - 130	195	95	195	95
	130 - 150	215	105	215	105
	150 - 170	235	125	235	125
	170 - 190	255	135	255	135
	190 - 200	275	145	275	145
	Wall clearances greater than 200 mm available on request
Length of restraint	L	180		180
Max. size of fastener		up to M10		up to M10
Attachment		Fischer SXR 10x60 FUS Distance form edge ar = 50		Fischer FAZ M10/10 Distance form edge ar = 80
Values apply for facing briks 115 mm thick with a superimposed load < 2 storeys, otherwise the anchors must be adapted in accordance with DIN 1053 Other dimensions on request

Recommended anchor selection
Superimposed load (m)	Load(kN/m)	Anchor spacing ak (m)	Load stage
< 0,67	< 1,387	0,25	0,3
< 1,50	< 3,105	0,25	0,8
(Assuming a 115 mm wide facing brick with γ=18kN/m³. Note individual evidence of attachment.)

Cross-references for additional information
Subject
Individual evidence of attachment in the anchorage base: Fischer FHB II-AS - For attachment in cracked concrete Hilti HVZ-R - For attachment in cracked concrete Fischer FAZ - For attachment in cracked concrete Hilti HST-R - For attachment in cracked concrete MBA - For attachment to the anchor rail UPAT UKA3 - For attachment in uncracked concrete UPAT UPM 44 - Other attachments
Technical regulation governing masonry support (DIN 1053)
Principles for dimensioning masonry support

Errata and technical changes reserved.

Single-bracket anchors EK-G