Installation instructions for supporting anchors with dowels

Set dowel in accordance with permit, fit wedge plateand supporting anchor on the dowelled anchor rod, ...

... Fit deep-offset washer and pre-assemble hand-tight with nut; ...

... Adjust height of supporting anchor by shifting the wedge plate, ...

... adjust pressure screw until it rests securely in place, ...

... Then apply tightening torque in accordance wit for the fasterner or in accordance with type-test, at least as follows:
M 10 = 15 NM
M 12 = 25 NM
M 16 = 60 NM